Better Rest SoClean 2 CPAP Guía de usuario descargar pdf (Pagina 12)

3. Turn on the Power switch located on the

underside of the unit. A Green LED will ﬂash

on the top of the unit for 30 seconds.

4. Within 30 seconds, press the button above

the SoClean 2 Go logo to begin sanitizing.

The LED will be solid Green.

If the Start button is not pushed within the

30 seconds while the Green LED is ﬂashing,

reset the unit by turning the Power button

Off and On to begin the process again.

Each time a cycle has run, you should turn

off the unit, as it will not run another cycle

until the Power button has been turned Off

and then back On. This is a safety reset.

If the LED is Red it means the batteries need to

be replaced / recharged. The unit will not run.

If the LED turns Red during the cycle it will

ﬁnish the cycle but the batteries will need to

be replaced / recharged before the next use.

Note: The SoClean 2 Go can be turned off at

any time during its operation by ﬂipping the

Power switch on the underside of the unit.

The SoClean 2 Go is preset to turn off after a

7-minute sanitizing cycle. After this cycle, it is

recommended that the mask be left in the mask

bag for another 2 hours to achieve maximum

sanitizing.

Using Your SoClean 2 Go continued

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Better Rest SoClean 2 CPAP Guía de usuario Pagina 12